Airfield Lighting Cable Manufacturer in India

Airfield Lighting cables

Airfield lighting cable is a type of industrial cable used in airports to power runway and taxiway lighting systems critical to pilot visibility. These cables are used in the airport lighting process, including runway end lights, runway end identification lights, runway edge lights, centerline lights, touchdown zone lights, and approaching lighting systems. Because of the unique characteristics of airport operations and the fact that they are used in safety-critical systems, airport lighting cables are engineered to be extra-durable and long-lasting.

Airports operate like a clock, and any interruption will result in physical and financial risks for those involved. Naturally, airfield lighting cables must also act as a clock.

Applications of Airfield lighting cable

While the primary function of an airfield lighting cable is to support runways and taxiways, they are also used for various lighting purposes within an airport. Obstruction lighting, navigational aids and all modes of lighting and control circuits are examples of typical applications.

When it comes to installation, airfield lighting cables are exceptional because they can be installed in various ways. These cables can be installed in metallic and non-metallic conduits and ducts, as well as direct burial. An aerial cable installation is also an option for airfield lighting cables. Airfield Lighting Cable Manufacturers In India ensures the cables versatile that they can be used for any purpose inside the airport that requires this form of installation. Direct burial and burial in ducts, on the other hand, are the most common forms of construction in runways and taxiways.

Simplistic Design of the Circuitry

Widely dispersed loads with single, relatively low-cost wires and cable exporter have runway edge lighting construction helps you route the supply and return cables from the source to the runway together. The runway edges are then looped with a single cable to supply each light. The benefit is obvious, given that runways can be more than two miles long.

Control of Lamp Lighting Level

Since the circuit maintains a steady current throughout, each load receives equal power, and each lamp runs at the same brightness. Consequently, there is no difference in lamp brightness due to voltage decrease, as can be expected for constant voltage circuits. Reduce the output current of the constant current regulator to reduce the light. Constant current regulators are available for three and five-step brightness controls. Airfield Lighting Cable Exporter in Delhi aims to allow for improvements in both good and bad visibility conditions.

Reliability

Series lighting systems can run for extended periods under unfavourable conditions. They will deal with several burned-out lights, degraded cable lines, and even shorts and fields. However, this is not recommended. To keep the processes running at optimum capacity, you can always schedule and conduct proactive maintenance.

Flexibility

Loads can be quickly added, moved, and removed. Furthermore, the same cable line will supply a diverse variety of loads. As a result, you can change the circuit loads, with the only problem being how to load the constant current regulator. Wires and cable exporter, on the other hand, necessitates an improvement in circuit ampere rating.

Semi-conductive tape is often spread over the insulation of airfield ground lighting cables. This is achieved to increase the cable’s resistance to heat and moisture, essential in an airport environment.

You May Also Like

About the Author: admin

Leave a Reply

Your email address will not be published. Required fields are marked *